JUST SAY "NO" TO Y-CABLES!
ModMyToys 2-Pin Power Distribution PCB is the perfect organizational solution for hard core modder's, water cooling enthusiasts and other power users that use a large amount of LED's in their systems or servers. Why use clumsy Y splitters that just add to cable clutter when you can have a clean point to distribute power to all your 2-pin LED's? These small PCB's are made of the highest quality and include and easy to install preinstalled black mount rail and Velcro strip. This allows you to mount virtually anywhere in your case including all those hidden places modder's like to route their cables to. For those that want the best look these have a black PCB and connectors. So, eliminate all those extra cables and install the ModMyToys 2-pin power distribution PCB to be a Pro!

**This PCB is meant to run off the motherboards LED power header which is usually 3.3V and distribute to 8 LED's. There are no resistors on the PCB and so it is straight through power.

Features:

• High Quality PCB
• Small, lightweight size fit almost anywhere!
• 2-Pin Male to 8 x 2-pin Male PCB.
• Preinstalled Velcro fastener for easy installation.

Options:

• 2-Pin Male to 8 x 2-pin Male
• 3-Pin Male to 3 x 3-pin Male
• 3-Pin Male to 4 x 3-pin Male + 4 x 2-pin Male
• 3-Pin Male to 5 x 3-pin Male
• 4-Pin Male to 3 x 3-pin Male
• 4-Pin Male to 4 x 3-pin Male + 4 x 2-pin Male
• 4-Pin Male to 5 x 3-pin Male
• 4-Pin Male to 8 x 3-pin Male
• 6-Pin Male to 3 x 3-pin Male
• 6-Pin Male to 5 x 3-pin Male
• 6-Pin Male to 8 x 3-pin Male
• 8-Pin Male to 3 x 3-pin Male
• 8-Pin Male to 5 x 3-pin Male
• 8-Pin Male to 5 x 3-pin Male
• 8-Pin Male to 8 x 3-pin Male

Notes:

2pin: Please note that these are really meant to have 8 LED with the same resistance. If mixing LED colors then note that to keep the same load on the circuit that these are the colors that you can mix off the PCB.

• Red, Amber
• Blue, White, Green, Purple

3pin: Please make sure you do not exceed your 3-pin fan headers maximum wattage by overloading more high wattage fans then the motherboard or fan controller can handle. Please consult your products manual.

4pin: For connection to PSU 4-pin Molex connector.

6pin: For connection to PSU 6-pin PCI Express connector.

8pin: For connection to PSU 8-pin PCI Express connector. *** Note this is NOT for the 8-pin EPS12V cable that goes to your motherboard.